User guide

USER SETTINGS
DE5468U 27
Recalling the Last Bypass Scheme
Arming the alarm system with several zones in the
bypassed state is in fact "partial arming". An
identical partial arming may be repeated by recalling
the last bypassing scheme (that was suspended and
memorized upon disarming the system).
Having entered your user code
successfully (see
above - Entering to the User Settings Menu), the
display will read:
PRESS
RESULTANT DISPLAY
SET BYPASS
Enter user code
RECALL BYPASS
At this point proceed as follows:
PRESS
RESULTANT DISPLAY
<OK> TO RECALL
RECALL BYPASS
You may now select any other item on the USER
SETTINGS menu or quit programming by clicking
. When <OK> TO EXIT is displayed - click
.
Programming 4 Telephone Numbers
Here you determine the 1
st
, 2
nd
, 3
rd
and 4
th
telephone
numbers to which the system will report event
messages that were defined by the system installer.
You can ask the installer to set some or all of the four
telephone numbers.
Having entered your Master User Code
successfully
(see above - Entering the User Settings Menu), click
button repeatedly (if necessary) until the
display will read:
SET PHONE NUMBER
You are allowed to program the 4 numbers as
follows:
PRESS
RESULTANT DISPLAY
1st private tel#
XXXXXXXXX
[Enter Tel. No.] XXXXXXXXX
XXXXXXXXX
1st private tel#
2nd private tel#
Continue the same way up to telephone number 4.
You may now switch to any other item on the USER
SETTINGS menu or quit programming by clicking
until <OK> TO EXIT is displayed and
then clicking
.
Setting the User Codes
Having entered your Master User Code successfully
(see above - Entering the User Settings Menu), click
until the display reads:
SET USER CODES
User Code 1 replaces the factory default master
user code, and should be assigned to the master
user of the system. This code can not be erased.
User Codes 2, 3 and 4 can be assigned to additional
users - family members, co-workers etc.
Codes 5 through 8 are assigned to “Latchkey
Users” (see Chapter 2 - Arming in the Latchkey
Mode, for an explanation of the latchkey mode).
Caution! Code “0000” is not valid! Do not use it.
Note: The duress code set by the installer (2580 by
default) cannot be selected as a normal user code. Any
attempt to program it will be rejected by the PowerMax
Pro.
Master user code is valid for all 4 system partitions. In
PowerMax Pro with partition feature, user codes 2 -8
are valid for predefined partitions only.
User codes programming process is as follows:
PRESS RESULTANT DISPLAY
user code 1: _ _ _ _
user code1: 1 1 1 1
user code 1: 6854
[4-digit
user code]
e.g. 6854)
user code 1: 6854
Programming user code 1 (master user code)
user code 2
user code 2: 1 1 1 1
[4-digit
user code]
e.g. 9854)
In PowerMax Pro Partition systems
access to part
U02: 1 2 3 4
Programming user codes 2 -8
and assigning them to the
desired partitions