Specifications

Installing the Visonic PowerLink
17
Step 3: Wall Mounting the Visonic PowerLink
Fasten bracket
to the
PowerLink
3
Mark and drill 3 holes in mounting
surface. Fasten the bracket to the
mounting surface with the screws.
1
2
Locate PowerLink
on the bracket and
push downward as shown
until a click is heard.
Router Configuration
After installing the hardware you need to configure the Home Router. Different Home
Router models have different login interfaces and configuration. The following
section includes a general description of the procedure and an example of a specific
Home Router model. Router specific instructions and guides for port forwarding can
be found at http://www.portforward.com.
Step 1: Determining the IP Addresses of Home Router and Visonic
PowerLink
1. Make sure you have in front of you the Visonic PowerLink Installation Form -
see appendix A.
2. On your PC click Start > Run.
3. In the Open text box type cmd and click OK.
4. at the Command Prompt type ipconfig and press Enter
Default Gateway
IP
A
ddress