Operation Manual
MENUS AND FUNCTIONS
24 D-304829 PowerMaster-10/30 G2 User's Guide
B.2 Reviewing the Zone Bypass Scheme
♦ Here you can quickly review the Bypass Scheme i.e. the zones that are set to be bypassed during the next
arming session.
1.
REVIEW BYPASS
Enter the [USER SETTINGS] menu and select the [REVIEW BYPASS]
1
option and press .
2
2. BYPASS LIST The display reads [BYPASS LIST]
or
Click the or buttons repeatedly to review all bypassed
zones in ascending numerical order. When done, click to exit.
9
3. Z04: BYPASSED
Z04: P1 P2 P3
4
Kitchen
B.3 Recalling the Zone Bypass Scheme
♦ Use this option to repeat (recall) the most recent Bypassed Scheme for use during the next arming session.
1. RECALL BYPASS
Enter the [USER SETTINGS] menu, select the [RECALL BYPASS]
1
option
and press .
2, 6
2.
<OK> TO RECALL
The display now reads [<OK> TO RECALL].
7
To recall the last used bypass scheme press .
3.
Bypass RECALLED
A "Happy Tune"
☺
sounds. The display reads [
Bypass RECALLED
] and
then returns to “
USER SETTINGS
" step 1.
9
☺
Return to step 1
Additional Information (section B.1 – B.3)
1
For detailed instructions on how to select User Settings –refer to sections A.1 and A.2.
2
This menu is displayed only if "BYPASS" was previously enabled by the installer.
3
a. The STATUS to the right of the zone number indicates whether the zone is READY, NOT-READY or
BYPASSED.
b. In the example on the left the display reads [
Z01: READY
] alternating with [
Living Room
].
4
This display will appear only if PARTITIONING was previously enabled.
5
a. If the zone you selected is "not bypassed", the display prompts you to press [
<OK> TO BYPASS
]. However,
if the zone you selected is already "bypassed", the display prompts you to press [
<OFF> TO CLEAR
].
b. To abort and return to the previous step press or
6
This menu is not displayed if Partition is enabled.
7
The display now prompts you to press [
<OK> TO RECALL
] i.e. to repeat the last used bypass scheme. To
abort and return to the User Settings menu, press
.
8
You can now repeat steps 2 - 5 to bypass or clear another zone. To end this session and to select other
menu options or to quit programming - follow the instructions in section A.2.
9
You can now select another option in the User Settings menu (see section A.1), or quit programming (see
section A.2).