Operation Manual

REVIEWING TROUBLES AND ALARM MEMORY
18 D-304829 PowerMaster-10/30 G2 User's Guide
B. Displaying Trouble Information
All trouble messages need to be reviewed and corrected as described below:
EXAMPLE: The kitchen device - zone No. 9 - has reported a low battery – the living room device zone No. 15 -
has been inactive, and an attempt to communicate a message to your telephone has failed. However, these
troubles do not prevent the system from being “ready to arm”.
To review the source of the current troubles one by one, click the button repeatedly as shown below:
PRESS RESULTING DISPLAY PRESS RESULTING DISPLAY
POWERMASTER-10
1
Z15 MISSING
(alternating)
Z09 LOW BATTERY Z15 MOTION SENS
(alternating) (alternating)
Z09 CONTACT LIVING ROOM
(alternating)
↓
KITCHEN COMM. FAILURE
↓
READY HH:MM
IMPORTANT! If the trouble beeps bother you, disarm the system again (even though it is already disarmed).
This will cancel the trouble beeps for 4 hours.
C. Reviewing Memory & Troubles at the Same Time
If alarms / tamper events are retained in the alarm memory and at the same time a state of trouble exists, the
display will first read the alarm memory followed by trouble events, as described in sections A & B above.
General Indications
After all trouble messages have been reviewed and if a SIM card is installed in the panel, the PowerMaster displays
the GSM signal strength indication, as follows: "GSM RSSI STRONG" / "GSM RSSI GOOD" / "GSM RSSI POOR".
If a PIR camera is enrolled in the system, the control panel will read "GPRS initialize" to indicate that the modem
is undergoing initialization. This message appears at the end of all trouble messages and immediately following
the GSM signal strength indication (if a SIM card is installed).
1
When working from the PowerMaster-30 G2 control panel, the display will read "POWERMASTER-30"