User guide
Table Of Contents
- PowerLink2 - User Guide
- Chapter 1 Getting Started
- Chapter 2 Installing the Visonic PowerLink2
- Chapter 3 Logging Into The Visonic PowerLink2
- Chapter 4 Visonic PowerLink2 Window
- Chapter 5 Managing Alerts and Alarms
- Chapter 6 Managing Home Devices
- Chapter 7 Managing Video Cameras
- Chapter 8 Managing the Security System
- Chapter 9 Managing Users
- Chapter 10 Managing System Configuration
- Chapter 11 Cellular Web Interface
- Glossary
- Appendix A Troubleshooting
- Appendix B PowerLink2 Installation Form
Managing Video Cameras
37
The current view from each of the cameras enrolled in the system is displayed with
the current image time and date.
To view a camera click the desired camera from the Available Cameras pane and it
will open at the Current view pane.
Important
A camera displaying No Data means that the PowerLink2 cannot retrieve the images from
the camera. This might be a short network hiccup or a communication problem.
A camera displaying Not Allowed means that the Master User disabled viewing of this
camera from the web interface at this arming mode.
For each camera you can now do any of the following:
• Click the and icons to switch camera preview ON or OFF.
• In camera preview, click the and icons to turn ON or OFF image
refresh.
• Click the icon to switch the camera view to the stored images from the
last alarm in the house. Clicking on the icon again returns camera the
current view of the house.
• Click the icon to open the Save Picture window and save the image as a
graphic file to the local hard drive.
• For cameras that support Pan & Tilt, use the to control the direction to
which the camera is pointing.
Current View
Camera Controls
Available Cameras