User's Manual

2. INSTALLATION
2.1. General Guidance
1. Keep away from heat sources.
2. Do not expose to air drafts.
3. Do not install outdoors.
4. Avoid direct sunshine.
5. Do not install near high-voltage electrical line.
6. Do not install behind partitions.
7. Mount on solid stable surface.
Warning! Do not obscure partially or completely the detector's field of
view.
Figure 3 - General Guidelines
2.2. Installation Procedure
Figure 4 - Bracket Mounting
Figure 5 - Opening the Unit
Figure 6a - Battery Insertion
Figure 6b - Battery Activation
Figure 7 - Closing the Cover
Figure 8 - Securing with Screw
Figure 9 - Mounting Detector on
Bracket
1. Mount the bracket on the wall.
2. Press in the point marked "F" in the drawing and separate the cover from the base.
3. Insert the battery while observing polarity-OR- If battery is already installed, pull the activation strip that
protrudes from the front of the detector.
4. Return the cover to the base until a click is heard (the snap is closed).
5. Secure detector with screw.
6. Align the detector with the bracket.
7. Slide the detector upward until a click is heard.
A. Surface mounting
B. Corner mounting
C. For back tamper
..................... .D. Cover
........ ............E. Base
F. Press in this point
Note: The detector transmits a low battery signal upon detection of low voltage. It is recommended to wait about 1 minute after battery removal, before
inserting the new battery.
MP-802 K9-85 shall be installed in accordance with the Standard for Installation and Classification of Burglar and Holdup Alarm Systems, UL 681.
Caution! Risk of explosion if battery is replaced by an incorrect type. Dispose of used battery according to the manufacturer's instructions.
D-306133 MP-802 K9-85 PG2 Installation Instructions 2