Installation Guide

D-308439 MP-802 PG+ Rev.0
Configuring the device parameters
1. Enter the DEVICE SETTINGS menu and select the required configuration as described in the
following table.
Table 1: Configuration options
Option
Action
Alarm LED
Define whether the alarm LED indication will be activated.
Optional settings: LED ON (default) and LED OFF .
Event counter
Define whether an alarm will be activated upon continued
motion (low sensitivity) or upon a single alarm event (high
sensitivity).
Optional settings: LOW sensitivity (default) and HIGH
sensitivity .
Disarm activity
Define whether the device is active when the system is
disarmed.
Optional settings: NOT Active (default), no delay , 5 s delay ,
15 s delay , 30 s delay , 1 min delay , 2 min delay , 5 min delay ,
10 min delay , 20 min delay and 60 min delay .
VERY HOT > 35°C [>95°F]
Define whether or not the control panel will report a very
hot alert when the temperature rises above the threshold
value for at least the Alert Delay duration value. Alert restore
will occur when the temperature drops 1°C (1.8°F) below the
threshold for at least the Restore Delay duration.
Note: The default threshold value for very hot is 35°C
(95°F).
Optional settings: See Configuring the Temperature Alerts.
COLD < 19°C [<66°F]
Define whether or not the control panel reports a cold alert
when the temperature drops below the threshold value for at
least the Alert Delay duration. Alert restore occurs when the
temperature rises 1°C (1.8°F) above the threshold for at least
the Restore Delay duration.
Note: The default threshold value for cold is 19°C (66°F).
Optional settings: See Configuring the Temperature Alerts.
4 MP-802 PG+ Wireless PIR Motion Detector Installation Guide