User guide

6 D-303166 AmberLink™ User Guide
SPECIFICATIONS
General Data
Pendant Transmitter Battery Life: 6 years (for typical use)
Frequency (MHz): 315, 868.
Indicators: 4 LED indicators.
Battery Pack: NI-MH 7.2 V, 1.3 Ah
Electric Power: 9VAC/0.1A (via 120VAC/60Hz transformer).
Compliance: Complies with FCC part 68 and part 15, and UL 1637 Home Health Care Signaling
Equipment. MCT-426 is designed to comply with UL 268 and UL 985.
The
system shall be installed in accordance with Chapter 2 of the National Fire Alarm Code,
ANSI/NFPA 72 (National Fire Protection Association, Batterymarch Park, Quincy, MA 02269).
LEDs:
Indicator Behavior Significance
1 RF Indication LED Lights steadily for
3 sec.
Received RF signal with strong or good
RSSI from any enrolled transmitter.
Blinks Received RF signal with poor RSSI from
any enrolled transmitter.
No light No RF signal received.
2 Trouble LED Lights steadily Indicates system trouble.
Blinks When GSM RSSI is poor.
No light No trouble.
3 Communication LED Light steadily Communication via PSTN/GSM is
online.
Blinks Phone line failure or is disconnected
(Trouble LED also lights steadily in this
condition).
No light Communication via PSTN/GSM is
offline.
4 Power LED Lights steadily AC power is connected.
Blinks AC power is connected but battery is
low.
No light AC power is not connected.
5 Backlight LEDs Lights steadily When the conditions below do not exist.
Blinks When there is AC failure.
No light When red indication LED blinks.
The left backlight LED between the
"HELP" and "CANCEL" buttons turns
OFF.