Instructions / Assembly

MILANO 200 INSTALLATION INSTRUCTIONS PAGE 9

SURFACE INSTALLATION

INSTALLING THE CASSETTES

Remove and discard the P-Pile/Weather Strip from the back of A-Screen

Cassette. Slide two L-Surface Mount Clips into the groove on the rear of the

Screen Cassette before proceeding [4.1]. Position the Screen Cassette, and

use I-#8 x 3/4”(19mm) Phillips Panhead Screws to secure L-Surface

Mount Clips to the opening [4.2]. Repeat for other side of opening.

4.1 L-Clips for Surface Install

4.2 Surface Installation

CRIMP WEATHER STRIPS

Crimp in the upraised channel lip on the inside of each corner of the C-Top

Guide Rail to keep the J-Pile/Weather Strip from moving, as shown at left.

OPTIONAL • INSTALLING THE SLIDE BOLT

ACCESSORY LOCK

Identify which of the two screen panels will be the one most often used to enter

and exit the home. You will install the Slide Bolt Accessory Lock on the interior

side of this inactive panel (the side less used).

In the interior groove of the pull bar, slide in an S-Slide Bolt at the

bottom and then another at the top. Make certain that the pointed end

of each Slide Bolt faces out [3.1].

PULL BAR

TOP

BOTTOM

3.1