User Manual
VNS2200 Amplifier & Controller Installation Guide – Version 2.00
8. Click on the Read Configuration button. This will tell you how many alerts the receiver module is set to hold.
9. Click on the Expanded Memory Alerts Configuration drop down menu and select how many alerts the receiver module needs
to hold.
Note
: The more alerts a receiver module needs to hold, the shorter the alert needs to be.
10. Click Update Configuration to change the amount of alerts the receiver module will hold.
Note
: Updating the memory configuration will erase all existing custom alerts previously programmed.
11. Enable the alert numbers that will hold a file by checking the box to the left.
12. Click on the Browse button and search for your WAV file.
13. Click on your file then click on the Open button to the right.
14. Your WAV file should now be in the File Name box. Repeat Steps 12 and 13 for as many files as necessary.
15. Click the Program button at the top of the programmer to upload your WAV files to your receiver module.
16. Disconnect the VNS2200 receiver.
If required, connect additional VNS2200 receivers and program as described above
VNS2256 (Solar Charger with Internal Battery) Option
Note
: The instructions below are for general reference only. Always review the instructions enclosed with the solar panel before
installation.
1. Follow steps 1-6 of the VNS2200 Amplifier & Controller Installation described above.
2. Secure the mounting bracket to a permanent structure facing the southern sky. Use screws or bolts appropriate for the
mounting surface.
3. Secure the solar panel to the mounting bracket (Image 3).
4. Adjust the solar panel to an angle between 45 and 60 degree from the horizon.
5. Tighten all screws to lock mounting bracket and solar panel in position.
6. Connect the solar panel male connector to the POWER port of the VNS2200 device.
7. Allow 24 hours for battery to recharge.
Ima
g
e 3