Product Manual

VISION X

MANUFACTURER RECOMMENDATION

For those unfamiliar with electrical wiring on vehicles, Vision X

recommends that all LED Lighting products are professionally

installed.

WIRING INSTALLATION INSTRUCTION

1. Find a suitable place to mount Relay Part (R1) leaving

enough room for Power & Ground wires Part (W1 & W2)

to reach the battery & the Deutsch connector Part (C1) to

reach the Light. Mount Relay.

2. Run Power wire (W1) & Ground wire (W2) to the battery.

Connect the Power wire (W1) to the Positive (+) battery

terminal and connect the Ground wire (W2) to the Negative

(-) battery terminal.

3. Run the Deutsch connector wire (C1) to the light and plug

in.

4. To connect the Halo wire Part (H1) tap the yellow wire to

an existing power source or on its own auxilary switch.

5. Disconnect the Switch Part (S1) at the white Plug Part (P1)

and run the wire through the vehicles ﬁ re wall to desired

mounting location inside the Cab [using a factory rubber or

plastic grommet is suggested].

6. Drill the hole to the required size for the Switch (S1) and

mount to desired position.

7. Reconnect the Switch (S1) to the Harness.

8. Test Light.