Product Manual

VISION X

WIRING INSTALLATION

1. Find a suitable place to mount Relay [Part R1] leaving enough room

for Power & Ground Wire [Parts W1 & W2] to reach the Battery & the

Deutsch Connector Wiring [Parts C1 & C2] to reach the Lights. Mount

Relay.

2. Run Power Wire [Part W1] & Ground Wire [Part W2] to the Battery. Con-

nect the Power Wire [Part W1] to the Positive (+) Battery Terminal & con-

nect the Ground Wire [Part W2] to the Negative (-) Battery Terminal.

3. Run the Deutsch Connector Wiring [Parts C1 & C2] to each Light and

Plug in. It doesn’t matter which Deutsch Connector plugs into which

Light.

4. Unplug Power Wire [Part W3(+)] from the Toggle Switch [Part S1]. Run

Power Wire [Part W3(+)] to the Vehicles Fire Wall at the point that you

will bring the Wire through to the inside of the Cab (using a Factory Rub-

ber or Plastic Grommet is suggested). Run Power Wire [Part W3(+)] to

the inside of the Cab. Note: This Wire can be extended if necessary.

5. Find a suitable place to Drill the Hole needed to mount the Toggle Switch

[Part S1] and Continue to run the Power Wire [Part W3(+)] to that loca-

tion. Plug the Power Wire [Part W3(+)] into Outside Pin of Toggle Switch

[Part S1]. It doesn’t matter which Outside Pin you use.

6. Drill the Hole to the required size for the Threaded Neck Portion of the

Toggle Switch [Part S1]. Mount Toggle Switch [Part S1].

7. Find a Factory Positive (+) Constant Wire, Positive (+) Ignition Wire, or

Positive (+) Parking Light Wire depending on how you want your Toggle

Switch [Part S1] to operate your Vision X Lights. This is the Wire that you

will connect the Power Wire [Part W4(+)] to. There are many diﬀ erent

ways to connect or “Tap” into a Wire (soldering is suggested).

8. Connect the Power Wire [Part W4(+)] to the Factory Positive (+) Wire

you have chosen.

1. If you selected a Constant Wire to Connect the Power Wire [Part W4(+)]

to then you will be able to use the Toggle Switch to turn you Vision X

Lights On & Oﬀ at all times.

2. If you selected an Ignition/Acc Wire to Connect the Power Wire [Part

W4(+)] to then you will have to have the Ignition turned on to use the

Toggle Switch to turn you Vision X Lights On & Oﬀ .

3. If you selected a Parking Light Wire to Connect the Power Wire [Part

W4(+)] to then you will have to have the Parking Lights turned on to use

the Toggle Switch to turn you Vision X Lights On & Oﬀ .