Specifications

1
Table of Content
Important Safeguards
Frequently Asked Questions
Quick Start Guide
Contents
Connecting to a TV Set
Remote Control
Insert the memory card
Control Functions
System setup
Glossary of Terms
Appendix (Troubleshooting Guide)
Technical Specifications
2
5
6
7
8
9
10
11
15
17
18
19
18
Appendix (Troubleshooting Guide)
Before contacting service personnel, please check possible causes according to the following
instructions.
Symptom Possible Cause Remedy
No power
1.Power supply not connected;
2.Bad contact between the power plug
and the receptacle;
3.The power of the receptacle is off;
4.Power switch is in the off position.
1.Incorrect signal connection;
2.The system is in the mute status.
No sound
No picture
No color
1.Incorrect signal connection;
2.Incorrect TV status;
1.Wrong selection of TV system;
2.Improper color adjustment;
3.Incorrect video output settings.
1.The remote control is not directed
at the sensor;
2.Low voltage of the RC batteries;
3.There is an obstacle between the
unit and RC.
Remote
control
malfunction
1.Connect to the power supply.
2.Plug again or replace a receptacle.
3.Switch on the receptacle.
4.Slide the power switch to on position.
1.Connect the signals properly.
2.Press the "Mute" button again.
1.Connect the signals properly.
2.Adjust the TV/AV status.
1.Se tup the TV system see "system
setup/preference page/TV type" for
reference
2.Readjust the color.
3.Check if the video output settings are
correct.
1.Direct the remote control at the
sensor.
2.Change to a new battery.
3.Remove the obstacle.
No reader
memory card
1.The memory card is inserted all the
way into the card slot and is facing the
wrong direction;
2.The memory card did not insert
completely.
1.Insert the memory card with the
correct direction.
2.Insert the memory card completely.