User`s guide

PaperPort Strobe for Macintosh Installation Guide
8
▼ NOTE: If you want to later change the SCSI ID, click the SCSI Info
button in the PaperPort Control Panel dialog box to see a list of
available SCSI IDs. To change the SCSI ID assigned to the PaperPort
Strobe SCSI cable, shut down your Macintosh computer, turn the dial
on the PaperPort Strobe SCSI cable to point to a different ID not in
use, and restart your computer.
▼
TIP: The CD also provides a variety of third-party software
applications that you can install and use with the PaperPort software.
Be sure to check the CD for other applications after you complete the
PaperPort software installation.
S TEP 3: C ALIBRATING THE S CANNER
Calibrating the scanner fine-tunes the grays and colors that appear on the
scanned item.
To calibrate the scanner:
1. Locate the calibration page that came with your scanner.
2. When a message appears asking you to calibrate the scanner, insert
the 9-inch edge of the calibration page into the scanner.
3. Click
Continue . A message appears, asking if you want to view the
One-Minute Guide. Continue to the next section for more
information about viewing the One-Minute Guide.
▼
NOTE: If you need to calibrate at a later time, click the Calibrate
button in the PaperPort Control Panel dialog box to start the
calibration. Follow the instructions that appear on the screen.