User`s guide

PaperPort Strobe for Macintosh Installation Guide
6
▼ NOTE: If you have other SCSI devices connected to your Macintosh
computer, it is recommended that you connect the Strobe SCSI cable
as the first device on the SCSI “chain.” If the PaperPort Strobe SCSI
cable is the last device, you may need to add a terminator to the cable.
If the PaperPort Strobe SCSI cable is the only device, you do not need
a terminator. See your computer dealer for information about a 25-pin
terminator.
5. Plug the 9-pin end of the cable into the larger, round port on the
back of the scanner.
6. Plug the narrow end of the power adapter into the PaperPort Strobe
SCSI cable. The connected scanner and cables should look like the
following figure.
Plug the 9-pin end of the PaperPort
Strobe SCSI cable into this port.
Plug this end of the
power adapter into the
Strobe SCSI cable.
Plug this end
of the power
adapter into
an AC outlet.