User`s guide

Step 1: Connecting the PaperPort Strobe SCSI Cable and Scanner

To connect the PaperPort Strobe SCSI cable:

1. Shut down your Macintosh computer.

2. Turn off the power to any devices connected to the Macintosh

computer. If you have already plugged the scanner into a power

outlet, unplug it now.

▼

CAUTION:

Always turn off the power to a connected device and

your computer before you connect or disconnect a device. This is

especially important for SCSI devices.

3. If you want to use a SCSI address other than the default setting 2,

select an address on the SCSI cable by turning the dial to point to the

number of the SCSI address you want.

▼

CAUTION:

Do not select 0, 7, 8, or 9 as the address setting. A system

conﬂict may occur with those addresses.

4. Plug the PaperPort Strobe SCSI cable into the SCSI port of your

Macintosh computer, make sure the connectors are seated securely,

and then tighten the device screws.

Turn the dial to

change the SCSI

address.

SCSI port

Device screws