User`s guide

PaperPort Strobe for Macintosh Installation Guide
2
W HAT Y OU N EED
To use the scanner and software, you need:
• A Macintosh computer with a 68030 or greater processor
• 6 megabytes (MB) of free RAM (10 MB if you use the OCR
software). If you have 16 MB or less of RAM installed on your
computer, it is recommended that you turn on Virtual Memory in
the Control Panel Memory dialog box.
• 20 MB of free hard disk space
• System 7.1.2 or later
• A color monitor (recommended, set to the highest number of colors
possible in the Control Panel Monitors dialog box)
W HAT ’ S IN THE B OX ?
Before you connect the scanner and install the software, make sure you
have all the necessary hardware, software, and written information,
shown in the following figure. If you are missing any items or notice
any damage, contact the dealer or mail order company where you
bought the scanner.
PaperPortStrobe scanner
Power adapterPaperPort Strobe
SCSI cable
PaperPort CD The PaperPort Getting Started
Guide and Installation Guide
Calibration page