Installation guide
Table Of Contents
- Table of Contents
- Welcome
- What’s in the Box
- The Visioneer 9020 USB Scanner
- What You Need
- STEP 1: Installing the PaperPort Software
- STEP 2: Connecting the Scanner
- STEP 3: Checking Out Your Scanner
- Three Ways to Scan Paper Items
- Scanning Paper Items with the OneTouch Buttons
- Scanning Paper Items from the Button Panel on the Screen
- Scanning 35mm Slides and Negatives
- Configuring the Scanner
- Scanning from the PaperPort Software
- Adjusting the Settings on the Scan Manager Pro
- Troubleshooting
- Cleaning the Scanner Glass
- How to Uninstall Your Scanner
- Contacting Visioneer America Technical Support
- Contacting Visioneer—International Technical Support
- Visioneer PhotoPort 9020 USB Scanner Specifications
CONFIGURING THE SCANNER 23
To display the Configuration dialog box from the Button Panel:
1. Right-click the button you want to configure.
The Configuration dialog box appears. The tab for the scan button
you clicked is selected for you.
ABOUT THE CONFIGURATION DIALOG BOX
The Configuration dialog box shows the current settings for each
scanner button.
The tabs across the top of the dialog box correspond to the buttons.
Clicking a tab shows the current settings for the corresponding button
on the scanner.
For example, the highlighted selections in the following figure show the
current settings for the Custom button because the Custom tab is
selected. The Custom button is set up to scan the item with the
configuration named Photograph for Editing, and then after the
scanning is finished, to open Microsoft Paint to display the scanned
image. The Format and Page(s) setting is to scan as a bitmap for a single
page item.