User guide

SCAN AND TRANSFER IMAGES WIRELESSLY WITH EYE-FI

Note: if you have configured a wireless network for the Eye-Fi card, you will need to either temporarily

disable your wireless network if possible, or remove the wireless network from the Eye-Fi card and then

add it back again when you are done. If the Eye-Fi card is within range of a configured wireless network

the scanned images will be transferred using the wireless network. Please refer to Adding or Removing

Private Wireless Networks on page 8.

Test Scan for the Direct Mode Network

1. Disable your wireless network or remove the network from the Eye-Fi card.

2. Disconnect the scanner from the computer and power cycle the scanner.

3. When the scanner power is back on, insert a photo in the scanner.

4. The scanner scans saves the image to the Eye-Fi card, and the card starts transmitting the image.

5. Open the Eye-Fi application.

6. Tap Connect to connect your mobile device to the Eye-Fi Direct Mode network.

7. When the scanned image appears in the document list you know that the Direct Mode connection is

working as intended.

Note: You can set the application to automatically connect to the Eye-Fi network. When the option is

selected, each time that you scan and open the Eye-Fi application, the device is automatically switched to

the Eye-Fi network without being prompted. From the menu options, press Settings, then Application

Preferences, and Automatically Connect.

Depending on how you chose to set your wireless network for this test, you can either re-enable the

network or connect the Eye-Fi card to the computer and add the wireless network to the Eye-Fi card.

Please refer to Adding or Removing Private Wireless Networks on page 8.

Now that your mobile device has been configured for first time use, you should not have to repeat these

steps. You can turn your wireless access point back on and whenever you are away from your network, you

can scan directly to your tablet or phone.

SCANNING TO EYE-FI

After you have successfully configured your mobile device, you can then scan any time following these

simple steps:

1. Open Eye-Fi on your mobile device.

2. Turn on the scanner power.

3. All of the LEDs will flash as the scanner initializes. When the scanner is ready to scan, a single LED

will be lit next to the first function represented by a camera icon.