User guide

SCAN AND TRANSFER IMAGES WIRELESSLY WITH EYE-FI
18
10. Tap your Eye-Fi card in the Eye-Fi Cards list.
The next screen displays your Eye-Fi card’s network information, including the password for the
Direct Mode Network. You can either write down the Direct mode Wi-Fi password, or you can press,
hold, then release your finger on the password to highlight it, and then tap Copy when that prompt
displays.
11. Tap Settings to return to the Settings screen.
12. Tap Done on the Settings screen.
13. Open the Wi-Fi settings for your mobile device.
If the Eye-Fi card is in the scanner, make sure the scanner is still connected to the computer and
powered on.
14. On your computer—in the Eye-Fi Center application on your computer, click on Start Direct Mode
Network.
If the card is in your scanner, the lights on the scanner will start flashing indicating that the Direct
Mode Network has been initialized.
15. On your mobile device—tap the Eye-Fi Card when it displays in the list of available networks under
Choose a Network.
16. Tap in the password field for the Eye-Fi Card network.
17. Input the password for the Direct Mode Network that was described in step 10 of theses instructions.
If you copied the password, press, hold, and then release in the password field, and then tap Paste
when that prompt displays.
18. Tap Join.
19. The Settings for the mobile device will now show that it is connecting to the Eye-Fi Card network.
Te chn i c a l no t e : if the Eye-Fi card doesnt display in the list of available networks for your mobile device
after a minute, try clicking Start Direct Mode Network in the Eye-Fi Center application again.
Note that if you had previously selected Photos and RAW files to be sent to your computer during the
initial setup, pairing your mobile device with the Eye-Fi card automatically changes Photos and RAW files
to be transferred to your mobile device.
Testing the Direct Mode Network
After you have connected to the Direct Mode network we recommend that you run a test scan to verify
the software is working as expected.
Note: if you have configured a wireless network for the Eye-Fi card, you will need to either temporarily
disable your wireless network if possible, or remove the wireless network from the Eye-Fi card and then
add it back again when you are done. If the Eye-Fi card is within range of a configured wireless network
the scanned images will be transferred using the wireless network. Please refer to Adding or Removing
Private Wireless Networks on page 8.
Test Scan for the Direct Mode Network
1. Disable your wireless network or remove the network from the Eye-Fi card.
2. Disconnect the scanner from the computer and power cycle the scanner.