Use and Care Manual

10 11
CLEANING AND MAINTENANCEOPERATION
TURNING ON/OFF
Turn the heater ON/OFF by pressing the “ON/OFF” button.
SELECTING A POWER LEVEL
Press the “HEAT” button repeatedly to select a Heat level between LOW, MEDIUM
and HIGH. The display will show the currently selected Heat level.
SETTING THE TEMPERATURE
The desired temperature can be set between 59°F and 95°F. Once the desired
temperature has been reached the unit will stop the heating function.
With the unit operating at the desired heat level use the + and - buttons to set the
desired temperature.
While the unit is heating, the thermometer symbol will ash.
When the room temperature is above the desired temperature the thermometer
symbol will be illuminated constantly.
TIMER BUTTON
The in-built timer will allow you to set the unit to turn on or turn o after a set
period of time. Please note, only one timer can be used at any time.
ON TIMER – The timer will turn on the unit automatically after the time set has
elapsed.
1. With the unit turned o, press the TIMER button, then set the number of hours’
time you desire the unit to start by repeatedly pressing the TIMER button.
2. Once the set time has elapsed, the unit will turn on automatically.
3. Press the POWER button before the time has elapsed and the unit will turn on
as normal and the timer will be canceled.
OFF TIMER – The timer will turn o the unit automatically after the time set has
elapsed.
1.
While the unit is operating, press the TIMER button then set the number of hours’
time you desire the unit to stop by repeatedly pressing the TIMER button.
2. Once the set time has elapsed, the unit will enter standby automatically.
3. Press the POWER button before the time has elapsed, the timer will be
canceled and the unit will turn o.
ATTENTION: Please shut o the unit and unplug from the mains before cleaning or
performing any maintenance.
CLEANING THE SURFACE
• Clean the heater with a duster or a soft wet cloth.
Do not use chemical solvents (such as benzene, alcohol or gasoline) as they
may cause irreversible damage. Make sure no water enters the control panel
or gaps in the casing.
• Do not run the unit until completely dry.
• Place the heater in its original box or cover to protect it from dust when not
in use.
• Store it in a cool dry place.
TROUBLESHOOTING
Do not repair or disassemble the unit by yourself, unauthorized repair attempts will
invalidate the warranty and may cause bodily harm.
PROBLEM POSSIBLE CAUSES SOLUTION
No Power
Power cord is unconnected. Connect the power cord.
There is no power from socket. Check socket is turned on.
The power switch on the rear
of the unit is turned o.
Ensure the power switch on the rear of
the unit is in the on position.
Odor emission
from unit
New unit. When the unit is
used for the rst time the fan
motor may produce and odor
which will dissipate within a
week of use.
No action required.
Strong
vibrations
and noise
Unit is not placed on a at
surface.
Place on a at surface. May put an
anti-vibration mat underneath.
Unit may be damaged.
If the heater is damaged discontinue
use and contact the service center.
If the above solutions do not resolve the problem please contact the service center.