Use and Care Manual

8
USAGE (Continued)
TURNING HEATER ON
Tostarttheheater,turntheOn/OPowerLevelControlfromtheOFFposition
to the LOW or HIGH setting. Then rotate the Thermostat Control clockwise
to the HIGH THERMOSTAT position as described below. (During the heaters
initial use, you may experience a slight odor or smoking. This is the result of the
heatingelementlubrication“burningo”.Thisisnormalandwillgoawayafter
a few minutes of use.)
POWER INDICATOR
The Power Indicator Light will illuminate when the heater or fan is turned on.
POWER CONTROL DIAL
This heater has two heat settings: High and Low. Use the higher setting (1500
watt) to raise the room temperature quickly. When the desired temperature is
reachedusetheLowsetting.Itisusuallysucienttomaintainacomfortable
temperature.
SETTING THERMOSTAT
After heater has been turned on and the room has reached the desired
temperature, slowly rotate the thermostat knob counter-clockwise until the
heatershutso(youshouldhearafaint“click”).Byleavingthethermostat
at this setting it will automatically maintain this temperature. To lower
temperature, rotate the knob further counter-clockwise (towards the LOW
position). To raise the temperature, rotate the thermostat knob clockwise
(towards the HIGH position).
Thermostat Control Dial
Caution Indicator
Light (on face)
Power Indicator
Light (on face)
Power Control Dial