Use and Care Manual

7
USAGE
ASSEMBLY INSTRUCTIONS
Simple assembly is required before you use this heater.
1. Remove Screw “A” on both sides of heater using a phillips screwdriver.
2. Rotate base cradle to align Hole “B” with new open hole from screw “A”.
3. Replace screw “A” through screw hole “B” on both sides of heater.
4. Heater is now ready for use.
HEATER OPERATION
Always operate the heater in the upright position following all instructions and
recommendations listed in this manual. HEATER LOCATION: Place the heater
in the area of the room that is coldest. HEATER CONNECTION: Plug heater
directlyinto120VoltAC,60Hzwalloutlet.Besureplugtstightlyinoutlet.A
loose connection may cause overheating and damage to the plug or heater.
NOTE: To prevent overloading a circuit, do not plug the heater into a circuit that
is servicing other electrical needs.
POWER/CAUTION LIGHTS
This heater is equipped with Power and Caution Lights. The power light will
illuminate when the unit is plugged in. The Caution Light will illuminate when
theunitoverheats.WhentheCautionLightisilluminated,turnoandunplug
the heater. Follow the “Important Safety Features” located in this manual.
BEFORE AFTER