Specifications

29
Advanced Programming
Advanced Programming Options
The Acrobat LCD has advanced capabilities for modifying the programming of the
included remote control (when using multiple units) as well as changing the default
language used within the setup menus. These settings are completely optional and
should not be changed under normal circumstances. The information listed on the
following pages are for technical reference purposes only. Please see your Enhanced
Vision representative or call our toll-free technical support should it be necessary for
you to modify these settings.
Language Select
Thedefaultlanguageusedfortheonscreendisplay(OSD)maybechangedby
accessing the Advanced Programming Features menu on the Acrobat. This is
accomplished using a special key combination sequence (4321), accessed by pressing
the[+]and[MODE]buttonsonAcrobatcamerahead.Languageselectioncanbe
adjusted within the second menu level. Please refer to the chart on the following page
for detailed reference.
Remote Codes
By default, a single remote control (and
corresponding remote control code) is factory
programmed and used for all Acrobat camera
functions. While acceptable for most single-
use applications, when 2 or more Acrobats are
used within close proximity to each other (lab
setting), exclusive remote control over each
unit may be desired. Therefore, it is possible to
modify the sending/receiving codes of the
remote control and Acrobat head for exclusive
use, if desired. Up to 15 unique codes can be
assigned. For proper communication, both the
Remote control (transmit) and camera head
(receive) must be set to matching ID codes.
Please refer to the chart on the right for more
information.
Remote Control (Transmit) Code Change:
#28 (default/factory reset): •
Push MODE and FIND for 3 secs.
#15:PushMODEandLLM-for3secs.•
#24:PushMODEandULM-for3secs.•
#25:PushMODEandLLM+for3secs.•
#27:PushMODEandULM+for3secs.•
#07:Push+andFINDfor3secs.•
#11: Push + and LLM- for 3 secs.•
#14: Push + and ULM- for 3 secs.•
#23: Push + and LLM+ for 3 secs.•
#31: Push + and ULM+ for 3 secs.•
#08:Push-andFINDfor3secs.•
#09: Push - and LLM- for 3 secs.•
#10: Push - and ULM- for 3 secs.•
#12: Push - and LLM+ for 3 secs.•
#13: Push - and ULM+ for 3 secs.•