Specifications

Acrobat LCD Setup
13
1. Unpacking and transporting the
Acrobat LCD
During unpacking and transporting, be sure
to lift the Acrobat LCD by the built-in carry-
ing handle. Do not attempt to lift or carry
the LCD by the base. (See Figure 1)
2. Setup the Acrobat LCD
Place the Acrobat LCD on a flat, level sur-
face such as a table or desk.
3. Connect the AC power
Connect the attached power cord to an
available wall outlet. (See Figure 2) To offer
additional protection during an electrical
storm, a surge protector may also be used
and is recommended.
4. Turn the power on
Ontherear,rightsideoftheAcrobatLCD,
flip the switch from the 0 to l position (See
Figure 3). The LCD screen and Acrobat
CamerawillautomaticallyturnONinafew
seconds. An image of what the Camera is
pointing at should appear on the LCD
screen.
TurnthepowerOFFbyflippingthesame
switch back to the 0 position. However,
leavethepowerONforthistraining 
section.
Figure 1
Figure 2
Figure 3