User`s guide

Chapter 4 - The Vision Menus 85
End angle: This number will determine the degree amount that the arc will
end.
Zero degrees is at 12 o'clock.
270 or -90 degrees is at 9 o'clock
90 or -270 degrees is at 3 o'clock
180 degrees is at 6 o'clock
If you have an arced line and want the line to be straight again, click on the
clear button and then click on Okay.
The page up and page down keys will move you up and down from line to
line.
Note: If you go into the autoplate feature after you have a line that is arced,
autoplate will erase the arc parameters. You will need to enter the arc
parameters after you are finished using the autoplate feature.
Easy Arc