User`s guide

Chapter 4 - The Vision Menus 51
Note: Vision defaults the Job Load and Job Save directories to your hard
drive C and in a directory called \Viswin\Jobs. If you would like to change
the default Job Load and Job Save directory, you must do the following. Go
to the Windows Start Menu, then to Programs, then to Vision Engraving
Software and click on Edit Vision defaults. This will bring up the
Cipher.sys file into the Windows Notepad. Go to the section in the file that
says Default Job Load Directory and change it from C:\VisWin\Jobs to the
drive and directory that you installed Vision into. You will also need to
change the Default Save Directory.
Import Job
This feature allow you to import a job created in the Dahlgren Superpro
program. Selecting this feature brings up the Import Job Layout window.
Note: If your job is on a floppy disk, it is recommended that you copy it to
your computer’s hard drive first. Click here for instructions on how to do
this.
Note: Vision defaults the Dahlgren Superpro jobs into your hard drive C
and in a directory called \Viswin\SpJobs. If you would like to change the
default job import folder, you must do the following. Go to the Windows
Start Menu, then to Programs, then to Vision Engraving Software and click