User`s guide

Chapter 5 - Other Features 151
Re-Engrave
Re-Engrave is a very important feature. There are two types of re-engrave:
plate Re-Engrave and line Re-Engrave.
Plate Re-Engrave is done easily by pressing the F1 button on the Vision
Serial Controller Series I, the B1 button on the Vision Serial Controller
Series II or the Home/Save button on the VE-810 Engraver. When you
press one of those buttons, the start light will turn green. All you need to do
is press the start button and the entire job that was last engraved will
engrave. It does not matter if the job has been closed or not, but Vision
Windows must remain open.
Line Re-Engrave comes in handy especially in multiple jobs in which a
certain line or group of lines did not engrave completely. If you would like
to re-engrave a line, press the F8 or F7 key. This will bring up the display
of the job on the screen. Click on the line that you would like to re-engrave
and press the F9 key. This will bring up the Execute Layout screen.