User`s guide

12 Vision Software User's Guide
which this limitation is contravened by law, liability is limited to the amount
that the affected party has paid for VISION, or in the event that VISION
was registered with a third party for payment to Western Engravers Supply,
Inc., liability is limited to the amount that was received by Western
Engravers Supply, Inc. from that third party.
System Requirements
Below are listed the system requirements for VISION to work effectively.
At the bottom of each component are some recommendations for most
efficient operation.
Operating System:
Microsoft Windows ’95, '98, NT, 2000 or ME
Minimum Computer:
PC Pentium 120 or higher
120 Mbyte Hard Disk
32 MB of RAM (64 MB of Ram on Windows NT &
2000)
SVGA Monitor (800 x 600 resolution)
A mouse supported by Windows
One open Serial Port (to connect to Vision Controller)
CD ROM Drive
One open Parallel Port (only when software protection
key is needed)
Recommended Computer:
Pentium 400 or above
1 Gbyte Hard Disk or above
64 MB of RAM (128 MB or Ram on Windows NT & 2000)
SVGA Monitor (at least 800 x 600 resolution)
A mouse supported by Windows
One open Serial Port (to connect to Vision Controller)
CD ROM Drive
One open Parallel Port (only when software protection key is
needed)