User manual

VE810 Series 3 User Manual96

Apply isopropyl alcohol to a paper towel and wipe down the Y-Axis leadscrews and the stainless steel

rails for the t-slot table.

NOTE: Clean the leadscrew, rail and baseplate (the area underneath the table) with the table in the fully

extended (forward) and fully retracted positions.

Raise and lower the spindle to access the upper and lower sections of the spindle rail. The rail is

located behind the spindle. Apply isopropyl alcohol to a paper towel and wipe down the sides and front

of the spindle rail.

Move the Spindle down to expose the Z-Axis leadscrew for cleaning. Apply isopropyl alcohol to a paper

towel and wipe down the Z-Axis leadscrew.