User manual

VE810 Series 3 User Manual94
© 2012 Vision Engraving and Routing Systems
Back Cover Screws
Remove the five back cover screws (shown below). The center screw does not absolutely need to be
removed. It holds a cable clamp inside the back cover of the machine. To remove the center screw,
reach inside the machine with a 11/32" nut driver to hold the nut and remove the screw with a Phillips
screwdriver from the back of the machine.
Spindle Cover
To remove the spindle cover, slide the cover up. Squeezing the sides of the cover will facilitate removal.