User manual
Step by Step Operation 55
© 2012 Vision Engraving and Routing Systems
Once the file has been set up, select the Engrave Icon and from the Materials selection drop down list,
select Engravers Plastic(Engraving). In the picture below, the Cut Toolbox shows that the Vacuum, Prox,
Dry Run, and Spindle are all enabled. Since this is the second example job, sending a Dry Run job to
the engraver is suggested. Select the Engrave Icon to send the file to the engraver.
If the Dry Run showed no set up errors, the job can be re-sent to the engraver with the Dry Run
disabled.
Place the material on the table (shown with Multi Mat on the t-slot table to hold the engraving material in
place), and press the start button on the machine to begin engraving.