User manual

VE810 Series 3 User Manual40
© 2012 Vision Engraving and Routing Systems
Edge Guides: The t-slot table edge guides need to be adjusted to the thickness of material that you
are engraving. If they are higher than the material's surface, the nose cone may ride on top of the
edge guides and the machine may not engrave characters completely.
Edge Guides (Side View)
To adjust the edge guides, loosen the edge guide thumbscrews and raise them above the surface of
the T-slot table. Place the material on the table, then loosen the edge guide thumbscrews and lower the
edge guides until they are even with (or just below) the material surface. Tighten the edge guide
thumbscrews. This process should be repeated any time materials of different thicknesses are to be
engraved.