User manual

Installation 31
© 2012 Vision Engraving and Routing Systems
Stop button - The stop button is used to stop the machine from engraving. If you
press the stop button while the machine is engraving, the VE810 will stop immediately, lift the cutter up
from the material, shut the engraving motor off and turn the vacuum off. Once you are ready to
engrave, you must press the Goto Home button to move the spindle back to the home position. Pressing
the start button will recall the job. Pressing the start button again will run the last job. You can re-engrave
the previous job, or send a new job to the machine
B3 Button - The B3 button will toggle the jog speed between Fast, Medium and Slow. The
current jog speed can be seen on the LCD screen.
X & Y Jog buttons - The X & Y jog buttons are used to move the position of the
spindle on the T-Slot table work area. This is used to position graphics, or to move the material. The X
jog buttons will move the engraving spindle left and right. The Y jog buttons will move the t-slot table front
to back. The machine will jog at the speed displayed on the LCD screen (medium, slow or fast).
Pressing the B3 button toggles between speeds. As you use the X & Y jog buttons, the spindle position
will be displayed on the LCD screen.
Z Jog Buttons - These will move the spindle up and down. These buttons are commonly used
for setting the surface of your material when you are not using the proximity sensor. The spindle will jog
up and down at the speed displayed on the LCD screen (medium, slow or fast). Pressing the B3 button
toggles between speeds. As you use the Z jog buttons, the spindle position will be displayed on the LCD
screen.