User manual

Chapter 1 - Before You Begin 7
Check to see that all of the items are included. Should any of the contents be missing,
damaged, or of the incorrect type, please call your sales representative or Vision
immediately.
Step 2:
Prepare a clean, level surface to put the engraving machine on. Carefully lift the machine
out of the carton and place it on the table.
Step 3:
After unpacking the machine, make sure that you SAVE THE CARTON, FOAM PACK and
ANY OTHER BOXES. They can be reused in the event the system must be transported
to another location or returned for service. Improper packaging for shipment can damage
the table or controller and may void the warranty.
Machine Description & Terminology
This chapter briefly describes the major components of the VE-810 table. Figure 1.1
shows a labeled drawing of the VE-810 Engraver. This chapter will help you identify the
parts of your table discussed elsewhere in the manual.
*Optional equipment such as accessory vises, clamps, fixtures or vacuum systems
may have been included with your system. For information regarding this
equipment, see the individual instructions for these options. For descriptions of
controllers, computers, and software used in your system, see the manuals from the
manufacturers of these units.
TABLE SPECIFICATIONS:
Z-Axis Clearance: 1 inch (25.4 mm)
(Definition: the distance between the bottom of the spindle and the work surface)
Z-Axis Stroke: 1 inch (25.4 mm)
(Definition: the travel distance of the Z-axis mechanism or spindle)
Table Resolution: .001 inch
(Definition: the smallest controlled motion the table is capable of)
Engraving Area: 8” x 10“ (203.2 mm x 254 mm)
Overall Dimensions: 14 1/2” Tall x 19“ Wide x 22” Deep
368 mm Tall x 483 mm Wide x 559 mm Deep
Table Top: Removable T-Slot
Shipping Weight: 65 lbs.
Shipping Dimensions: 27“ x 22” x 19“