User manual

6 VE810 Engraver Manual
Ø Be sure to hold the plug, not the cord, when disconnecting the controller from an
electrical socket or power source.
Ø Place the machine in a location with low humidity and a minimum of dust. Avoid
placing the equipment in direct sunlight or in locations with excessive heat. Follow the
maintenance instructions for proper cleaning of the controller air filter.
Ø If your machine does not operate properly; in particular, if there are any unusual
sounds or smells coming from it, immediately unplug it and contact a service
technician or your local distributor.
Ø Unplug the machine when it is going to be left unused for an extended period of time.
Unpacking and Taking Inventory
The VE-810 engraving system has been shipped in one carton, unless other accessories
have been ordered with the machine that will not fit in the box. Examine the condition of
the box for external damage. In the event of apparent external damage, notify your
shipping carrier upon receipt, and call your sales representative or Vision immediately.
Note: The shipping container is considered reusable and should be stored for use in the
event of service need or upgrade.
Step1:
Open the foam packed shipping carton. In the top of the carton will be a cardboard box
with all of the machine accessories (including this manual). Open the accessory box and
the following items should be included:
ü 1 VE-810 Machine
ü 1 VE-810 Warranty Card
ü 1 Vision Software Manual
ü 1 Vision Software CD
ü 1 Vision Keyboard Template
ü 1 Vision Font Catalog
ü 1 Operations Manual
ü 1 Mouse Pad
ü 2 Spare 5 Amp Fuses
ü 1 Spare 1 Amp Fuse
ü 1 Power Cord
ü 1 Interface Cable
ü 1 Interface Cable Adapter (25 pin to 9 pin)
ü 1 Extra 14“ Motor Belt
ü 1 Allen Wrench Set
ü 1 Cutter Wrench