User manual

Chapter 4 - Optional Accessories 35
If you insert the material in the top left origin, you will set up to engrave the same way that
is discussed in Chapter 3. If you set up to engrave as a top center origin, you will need to
make some changes. The first thing that you need to do is to place your object into the
versa vise. Once it is in, use the X jog key to move the spindle over to the top of the
object. Then use the Y jog key to move the spindle over the top edge of the material.
Then follow the steps for setting the surface explained in Chapter 3, except when you
send the job to the engraver (F9), you will change the driver select to VeTCtr.cdf. This will
tell the machine that you are using the top center. Figure 4.4 shows where to change to
the VeTCtr driver.
(Figure 4.4) Changing to Top Center Origin in Vision
Other clamps can be added to the versa vise to allow for the holding of irregular shaped
objects. Below are some figures that show different configurations.