User manual
Chapter 3 - Operations 31
the material. Next, press and hold the Z up jog button until the spindle reaches the
highest point. Press the set surface button. The spindle will move down. Now press and
hold down the Z down jog button until the cutter touches the engraving material. Press
the Z down jog key a little bit more. This will ensure that the depth of cut is consistent.
Press the set surface button again. The spindle will now move to its original position.
The surface is now set. From the Vision software, press the F9 key to send the job to the
VE-810 engraver. You will get the following screen:
Since we are using a burnishing, we need to have the spindle rotate, so click on Rotary
Engrave from the Execute Layout screen and then click OK. You will see that the green
light near the start button will start to flash. This means that there is a job in the VE-810.
Before you press start, press the X left jog button until the spindle is all the way to the left
and press the Y up jog button until the T-slot table is all the way to the back. Now press
start. The job should now engrave. If there are any problems, press the stop button
immediately.