User manual

Chapter 3 - Operations 27
Since we are using a diamond drag, we do not need to have the spindle rotate, so click on
Diamond Drag from the Execute Layout screen and then click OK. You will see that the
green light near the start button will start to flash. This means that there is a job in the
VE-810. Before you press the start button, press the left X jog button until the spindle is
all the way to the left and press the Y up jog button until the T-slot table is all the way to
the back. Now press start. The job should now engrave. If there are any problems, press
the stop button immediately.
Rotary Engraving
In this section, we will set up to engrave with a rotating cutter. Figure 3.2 below shows the
VE-810 spindle with a rotary cutter.