User manual

Chapter 2 - Installation 17
Connecting the Table
There are two connections that must be made to the VE-810 engraver. The power input
and the serial connection (See Figure 2.1)
(Figure 2.1) The VE-810 rear view
1. Serial Number Tag
2. Power Input
4. Serial Connection
3. Fan
The power input is where you plug the power cord into the VE-810. The VE-810 can
accept 110 volt or 220 volt power depending on which the machine is set for. To change
the power input setting, you must follow the following instructions:
1. Locate the fuse assembly on the machine’s rear back panel.
Note: Picture for Fig. 1 shows the fuse box removed from your machine, you will NOT
have to remove it from your machine to complete this procedure.
2. Use a small screwdriver to snap out the fuse and voltage ”select“ cartridge.
3. Lift the locking tab on the fuse cartridge and pull out the fuse holder. (See Fig. 2 below)
4. Lift the locking tab on the voltage ”select“ section of the cartridge. (See Fig. 3 below)
5. Rotate the voltage selector to the desired voltage and re-insert it into the fuse cartridge
until the voltage shows through the window. (The close up picture shows the arrow
pointing to the selected voltage.)
6. Re-insert the fuse holder into the cartridge. (See Fig. 4)
7. Insert the cartridge back into the connector housing. (See Fig. 4)