Owner`s manual
7. Route the power and inputs cables as shown and clip the covers into place:
6
ENGLISH
1. Cable routing at top and bottom
of wall plate
1. Wall plate cover
2. Boom cover
3. Wall plate inserts (use to cover the boom
adjustment range hole on the wall cover)
ALTERNATIVE EXTENSION POLE FITTING
The TM-UST can be extended to up to 1.5m for short throw projectors. This is achieved
by tting the extension pole to section 1, then tting section 2 to the extension pole. To cut
excess length o the extension pole follow this process:
Turn the projector on. Slide section 2 up and down the extension a.
pole into position so that the image matches the width of the screen/
whiteboard.
Mark the excess length of the extension poleb.
Turn the projector o. Remove the projector and section 2 assembly from c.
the extension pole.
Cut the extension pole shorter with a hacksaw at the projector end.d.
Replace the projector and section 2 assembly and nish installation.
WARNING: THE SAFE WORKING LOAD LIMIT WITH THE EXTENSION POLE IS
4.5KG. DO NOT FIT THE EXTENSION POLE TO SECTION 1 IF SECTION 1 HAS BEEN
SHORTENED.