Service manual

36
CHAPTER 3: Troubleshooting
3.7 TROUBLESHOOTING – iPod Issues
1) SYMPTOM:
a. Cannot connect the iPod prompt shown on the screen (Touch console only).
2) SOLUTION:
a. Confirm whether the iPod cable is well-connected, not broken or damaged.
b. Replace the iPod cable and try again. Refer to the figure below regarding the iPod cable and the iPod
board.
c. Check the FFC connect wire for damage. If any is found replace the FFC wire.
d. If the iPod still cannot connect, replace the iPod PCB board.
e. If the iPod still cannot connect after the iPod board was replaced, replace the UCB.
iPod Wire
iPod PCB Board
FFC connect wire
iPod FPC connected to
the UCB
FFC wire connected from
the iPod board to the UCB
iPod
b
oard
iPod wire