Owner`s manual

ENGLISH



2. IR Input receiver

The Techconnect Control has now assigned that code to the button and is no longer in learn

mode. Repeat all steps including step (a) to program the other buttons. Note: If you are

programming one of the middle buttons in dual command mode it will remain in learn mode

after you have taught it the ﬁrst code. You should now press the second command on the

original remote control. The second code will be assigned to the same middle button and the

module will revert out of learn mode.







2. Too close

5. INSTALL CONTROL MODULE INTO



taught the Control Module the IR codes,

install the module into the Techconnect

faceplate, plug in the IR Blaster cable





Stuck on the IR receiver built in to

 

2. Sitting near the IR receiver

3. Attached to a wall directly facing

the IR receiver









