Owner`s manual



Mando de control original

2. 

The Techconnect Control has now assigned that code to the button and is no longer in learn

mode. Repeat all steps including step (a) to program the other buttons. Note: If you are

programming one of the middle buttons in dual command mode it will remain in learn mode

after you have taught it the ﬁrst code. You should now press the second command on the

original remote control. The second code will be assigned to the same middle button and the

module will revert out of learn mode.





Ángulo incorrecto

2. Demasiado cerca

5. INSTALE EL MÓDULO DE CONTROL EN





el módulo de control, instale el módulo en

la placa frontal de Techconnect, conecte el









 

2. Apoyado cerca del receptor de

 



orientada de frente al receptor

 













