User manual

SP-5000M-GE2 / SP-5000C-GE2
- 36 -
5.3.7.2 IN and OUT matrix table
The following table shows the input and output matrix table.
Table 11. GPIO IN and OUT matrix table
Selector (Cross
point switch output)
Source signal
(Cross point switch input)
LOW
              
HIGH
              
Line 5 - 12P OPT 1 In
              
Line 6 - 12P OPT 2 In
              
NAND 1 Out 1
              
NAND 2 Out 1
              
Pulse Generator 0
              
Pulse Generator 1
              
Pulse Generator 2
              
Pulse Generator 3
              
User Output 0
              
User Output 1
              
User Output 2
              
User Output 3
              
Software Trigger
              
Action 1
              
Action 2
              
FVAL
              
LVAL
              
Exposure Active
              
Acquisition Trigger Wait
              
Acquisition Active
              
Frame Trigger Wait
              
Frame Active
              
Line 10 - TTL 2 In
              
Line 11 - LVDS 1 In
              
Extension GPIO
Connection
NAND 2 In 2
Pulse Generator 0
Pulse Generator 1
Pulse Generator 2
Pulse Generator 3
Trigger Source
Pulse Generator
Clear Source
Line Source
Line 9 - TTL 3 Out
NAND 1 In 1
NAND 1 In 2
NAND 2 In 1
Trigger
Selector
Line Selector
Pulse Generator
Selector
Acquisition Start
Acquisition Stop
Frame Start
Line 2 - 12P OPT Out 1
Line 8 - TTL 2 Out
Line 3 - 12P Opt Out 2
Note: As for Line 8, Line 9, Line 10 and Line 11 are available if AUX Type 3 is used for AUX connector
configuration.