User manual

Page 8
(Figure 2.1) The Phoenix 1212 (non-moving T-slot table)
10. Quick Lock Vise
1. Table Base Plate
4. T-Slot Table
11. Stantions
(risers)
8. Y-Axis Stepper Motor (Dual)
7. Breakout Connector
8. Y-Axis Stepper
Motor (Dual)
3. X-Axis Stepper Motor
2. X-Axis Linear Rails
9. Engraving Motor
5. Gantry Assembly
6. Carriage Assembly
6. Carriage Assembly. The carriage assembly houses the engraving spindle, Z-Axis
mechanism and engraving motor. The carriage moves along the gantry assembly on a V-Rail.
The carriage assembly holds the engraving spindle; it raises and lowers the spindle during the
engraving process using a lead screw and stepper motor.
7. Breakout Connector. This electrical access is used to connect the table to the system
controller. The breakout connector is located on the left side of the table near the back.
8. Y-Axis Stepper Motors (2). Drives the carriage in the Y-Axis. Incorporates a dual drive
mechanism.
9. X-Axis Stepper Motor. Drives the carriage in the X-Axis. Located under the protective
sheet metal cover.
10. Engraving Motor. Drives the spindle for rotary engraving.
11. Quick-Lock Vise. A “cam” type locking device that allows quick change of parts for
engraving..
12. Stantions (Risers). Larger ones are pictured in Fig.2.1.and come standard with the
Phoenix Engraver. For added clearance, shorter ones may replace these to get more
distance between the T-Slot table and the spindle.
Chapter 2
13. Spindle
Up/Down
Knob