User manual

Page 5

The engraving system has been shipped in more than one carton. Examine the condition of all

containers for external damage. In the event of apparent external damage, notify your carrier upon

receipt, and call your sales representative or Vision immediately.

Note: The shipping containers are considered reusable and should be stored for use in the event

of service need or upgrade.

Step 1.

Open the foam packed shipping cartons. The following items should be included:

a. The table

b. Control unit

c. Control unit accessory kit (with power strip)

d. Optional accessories you may have purchased

Check all the items in the cartons to assure they are of the correct type. Should any of the

contents be missing, damaged, or of the incorrect type, please call your sales representative

immediately.

Step 2.

Prepare a clean, level surface to put the engraving table and controller on. Carefully lift the table

and controller out of the cartons and place each on the table.

Step 3.

After unpacking the table and control unit, SAVE THE CARTONS AND FOAM PACK and

ANY OTHER BOXES. They can be reused in the event the system must be transported

to another location or returned for service. Improper packaging for shipment can

damage the table or controller and may void the warranty.

Chapter 1

Chapter 1:Chapter 1:

Chapter 1:

packing and Tpacking and T

packing and T

aking Inaking In

aking In

entent

ent

oror