User manual

Page 30
Chapter 6
(Figure 7.14) Attaching the Vacuum Hose to the Phoenix Carriage
Right Side of Phoenix Carriage
To Install:
1. Remove two screws from carriage (a & b).
2. Spread apart plastic clamps (c) and place
around hose (d)
3. Place lock washer on the new longer screw
& insert through holes in the clamp (e).
4. Screw clamp (with hose inside) onto
carriage using the supplied hex wrench.
5. Put new vacuum nosecone on spindle
(adjust micrometer if needed).
6. Attach clear end of hose to new vacuum
nosecone.
a
b
c
e
d
vacuum nose cone