User manual

Page 28
(Figure 7.15) Vacuum Chip
Removal System
The Vacuum Chip Removal System
The optional vacuum chip removal system is designed to simplify the engraving process and
minimize wear and tear on the engraver. The vacuum chip removal system uses a vacuum nose
cone to remove chips created during the engraving process before they have the chance to
create problems. The quiet pump, coupled with the microfine-layered filters assures that your
unwanted chips are whisked away effortlessly. The vacuum pump canister uses replaceable
filters that can also be reused, to assure maximum efficiency and cost-effectiveness.
The vacuum chip removal system allows prompt removal of chips and dust created in the
engraving process, reducing contamination and overheating in the spindle area. Chip removal
also prevents the cutter from skipping over letters due to stray particles. This vacuum chip
removal system is available with or without a Vision vacuum nose cone.
Chapter 6
Vacuum Pump System
Elbow pipe connector
Vacuum filter canister
Vac hose connector
(large end)
Vac hose
(2" clear)
Vac hose
(threaded)
Vac nose - black
Vac hose connector
(small end)
ALL PIECES CONNECTED