User manual

Importing Material
82
© 2014 Digital Vision
UM-2014.1-07
Event Controls
Use the Event Controls to :
Switch the selected event when multiple matches occur.
Disable events to prevent them being conformed or found.
Disable/Enable Event
When you Disable an event, you prevent it changing status such that :
A Found event will not conform (link) to material when pressing
Conform (it will stay Found)
A Needed event will not be found (it will stay Needed)
The Disabled state of an event is reset if you close and re-enter the
List Capture module.
Enable Event will reverse the disabled state and allow the event to take part in
capture and conform operations once again.